This post (below) deserves a separate post.
viewtopic.php?f=5&t=3
Quoting Ronald Garcia:
Hi Adam and Warr
Thanks for your reply.
Let us see the case of 78Se on Mg, in the attachment (GOSIA2_78SeonMg.zip) are my input files.
Other thing, when I use the BRIC method for conversion coefficients, with the same input files, I get the following error:
Unable to find conversion coefficients for 4.238 MeV
STOP Missing conversion coefficients statement executed
Best Regards,
Ronald
Whether or not this is a bug and in gosia2 (rather than a mistake in the input), the fastest fix is probably to try switching to the old input format for internal conversion data in the OP,YIEL section.
- Take out the OP,BRIC lines
- Find the syntax for ICC data in the OP,YIEL section of the manual
- Make sure you span the full energy range for all gamma decay energies
- If you have any energies that cross a K, L,... edge, put two ICC points on each side of the edge so that you don't have oscillations if you are using the Lagrange interpolation
Best,
Adam